Limpieza de ductos Panamá

Sector · Call centers

In a call center many people share each square meter: how its ducts are checked without stopping operations

A call center brings many people together on open floors, with equipment switched on and shifts that sometimes do not stop all day.

Limpieza de Ductos PanamáBy Limpieza de Ductos PanamáReviewed October 21, 20263 min readShare
Ventilación y ductos en el techo de un edificio comercial
Short answer

Duct cleaning in a call center is the camera inspection and cleaning of the inside of the air conditioning ducts serving the operations floors. It is scheduled by shift and by floor sector so service does not stop, and cleaning is done only where the camera shows it is needed.

What sets call centers apart

Many people in little spaceMore people mean more air to renew and more heat to remove. The duct serving the most densely grouped workstations is looked at first.
Equipment on for the whole shiftComputers, headsets and small servers add heat to the floor. The unit works under a high load, and its condition is reflected in the report.
Shifts that leave few windowsWhen the operation covers several time bands, the work is divided by floor sector and agreed with the shift supervisor.

Facts that help decide in call centers

  • In Panama: According to ASEP, cited by La Prensa on February 13, 2016, 92 concessions had been granted for call center services and 42 were operating. People employed in the activity went from 12,643 in 2012 to 8,500 the year before the article. These are figures from that date and not current ones. (La Prensa, Call center industry loses strength (2016))
  • Technical fact: s2OSHA states that CO2 can be used as a rough indicator of the effectiveness of ventilation and of excessive population density, and that high levels may indicate overcrowding or inadequate outdoor air. (s2OSHA, Indoor Air Quality in Commercial and Institutional Buildings (3430-04))
  • Peer-reviewed study: In a study carried out in a real call center, agents were slower at the post-call task when the temperature exceeded 25.4 °C. The authors attribute the heat to disputes over the thermostat and recommend restricting setpoint changes. (Federspiel et al., Indoor Air (2004))

Types of place within call centers

Type of placeWhat changes in the work plan
Call centersOpen floors with grouped workstations, worked on by sector
Contact centersService across several channels with staggered shifts, which allows going sector by sector
Customer service centersThe floor sector with the fewest agents logged in is chosen for each time slot
Technical support centersContinuous operation that forces the work to be split into short parts
Shared service centersCompany areas on one floor, with a single system that is reviewed from end to end
24-hour monitoring roomsRooms that cannot be switched off, so the intervention is agreed in parts

How the work is organized in call centers

  1. Map the floor. Which unit serves each sector is identified, along with how many people are logged in on each shift.
  2. Split by sector. With the supervisor, the floor is divided into sectors that can be left without staff for a short time.
  3. Hand over the report. Each sector receives its photos and a note on what was done and what comes next.

An example of what the report brings

An illustrative page from a call center report: floor 5, sector C. A photo of the return behind the workstations with built-up dust, a photo of the first duct section seen with the camera, and one decision line: clean the sector in the slot agreed with the supervisor or monitor it until the next report.

What you are left with at the end

  • A report by floor sector, with photos of the inside of the ducts
  • A note on the condition of the unit serving the most densely grouped workstations
  • The list of sections that could not be reached during the shifts
  • A suggestion of when to look again, based on how full the floor is

Reference sources

Frequently asked questions

No. The floor is divided into sectors and the work takes place in the one with the fewest people logged in, with the supervisor’s agreement.

Yes, if the building allows it and access is agreed with the administration. Night shifts are coordinated just like day shifts.

None directly. CO2 is an indicator of air renewal and of how many people are on the floor. The camera shows the condition of the duct and does not measure ventilation.

Yes. Access, elevator use and which units belong to the tenant and which to the building have to be coordinated with the administration.

There is no fixed frequency. It makes sense to look when the floor feels hot or stuffy, after adding workstations, and when the layout of the equipment changes.

It brings photographs of the inside of the ducts. It is organized by floor sector, so the supervisor knows which shift was affected and which was not.

Keep exploring

Related toolDuct inspection plannerEstimate the level of attention your system needs based on use and warning signs.Open planner →
Técnico con mascarilla en un espacio interior

Request an inspection

Do you want to know what your place needs?

Tell us what type of place it is and which area it is in. A camera inspection shows the inside of the ducts before anything is decided.

Scroll to Top